hello I see some post and see that people reporting all macs dead .I don't think its the macs that's are dead. I think virgin media have Tryed to sent a upgrade ?
CG2100D_VGUKS_v4.4..4R10_D20RG10s_20110218.bin
I seen this when I opened a file in notepad that I downloaded from the file manager in the h*******e v1.1 rev39.
my modem don't get an ip and dhcp fails and restarts scanning again. I have Tryed my whole list of macs that were all working untill just recently.I have Tryed to restore backup of non_vol and 2mb fullflash backup I had and still no joy .I have also reflashed hax******.1.1r39 DIAG and even tryed the hax******.1.1.r39Lite and still no joy. I then replaced coax with new high quality coax cleaned all connections thinking it might be to much signal to noise ratio and still no joy.
I even Tryed a new power supply because I have read that a bad power supply can cause same issue with stuck after ranging compleated but still no internet access
.yesterdayi was trying a old list of macs I recovered from a old laptop hard drive and after trying my 3rd Mac off new list I noticed that while scanning freq on reboot that the perfured ds. freq locked onto a different frequency 203000000 / and under signal the annex said Eurodocsis. before it locked at freq 402750000 and Annex was docsis .
Has my area been upgraded to docsis 3? or
have Virmin blacklisted moto SB5101 Hax******.1.1r. 39?
or has the security been changed in bpi?
Or am I doing somthing wrong ?
any info would be greatfully recived.
have a good day from richiev Uk
CG2100D_VGUKS_v4.4..4R10_D20RG10s_20110218.bin
I seen this when I opened a file in notepad that I downloaded from the file manager in the h*******e v1.1 rev39.
my modem don't get an ip and dhcp fails and restarts scanning again. I have Tryed my whole list of macs that were all working untill just recently.I have Tryed to restore backup of non_vol and 2mb fullflash backup I had and still no joy .I have also reflashed hax******.1.1r39 DIAG and even tryed the hax******.1.1.r39Lite and still no joy. I then replaced coax with new high quality coax cleaned all connections thinking it might be to much signal to noise ratio and still no joy.
I even Tryed a new power supply because I have read that a bad power supply can cause same issue with stuck after ranging compleated but still no internet access

Has my area been upgraded to docsis 3? or
have Virmin blacklisted moto SB5101 Hax******.1.1r. 39?
or has the security been changed in bpi?
Or am I doing somthing wrong ?
any info would be greatfully recived.

have a good day from richiev Uk