Before I begin, I would like to note that I know this information is available @ SBH, but I would like to have something here at this site for other folks to reference without being intimidated by the old Veteran site, so here goes...
Ok guys, I'm back in the saddle with a new virgin DPC3000. I hooked it up, the status page shows operational and all lights are on so im assuming it has taken the most recent update. I am able to view the status page but it says I do not have permission to view any of the other tabs such as
signal
status
log
setup
I'm gettin ready to split this baby in two and work some magic. What do I need to do first off? Im assuming just read the flash, make a full backup, then flash it with Forceware and roll with it. Is that it?
What Im trying to say is that since I have a Virgin, is there anything I should do that I will probably regret NOT doing later.
You remember my last fiasco with the DPC3000, but that one was abused before I got it. This one still has her knickers on.
Thanks
Ok guys, I'm back in the saddle with a new virgin DPC3000. I hooked it up, the status page shows operational and all lights are on so im assuming it has taken the most recent update. I am able to view the status page but it says I do not have permission to view any of the other tabs such as
signal
status
log
setup
I'm gettin ready to split this baby in two and work some magic. What do I need to do first off? Im assuming just read the flash, make a full backup, then flash it with Forceware and roll with it. Is that it?
What Im trying to say is that since I have a Virgin, is there anything I should do that I will probably regret NOT doing later.
You remember my last fiasco with the DPC3000, but that one was abused before I got it. This one still has her knickers on.
Thanks